Clogged drains, pipes and leaking faucets are some of the major frustrating issues homeowners experience once in a while. The other issue that is also frustrating and annoying is experiencing low water pressure in your home when you are trying to shower or fill up your bathtub. Your dishwasher and washing machine also get affected by this issue as they may take much longer to run a cycle than it should. This issue will not only stress you out but it will also cost you time especially if you intend on doing a number of chores in the house but your water isn’t cooperating. With that being said, let’s look at some of the possible causes for your low water pressure so that you can know what to do and also who to call.
Your house’s shutoff valve isn’t open all the way
If you find out that your home is the only one experiencing the issue, then you should check around your house for what could be affecting your pressure. One thing you could look out for is your shutoff valve. As a homeowner, it’s important that you familiarize yourself with how to find and shut off your main house shutoff valve. It’s usually located inside the house next to where the main city supply pipe enters the home. In the case of an emergency such as leakage or a burst pipe, the shutoff valve can be turned off to stop the flow of water. Though if your water pressure is too low, it could mean that your valve isn’t fully open. The level handle should be parallel to the pipe and if the valve has a wheellike handle, it should be turned counterclockwise in order for it to be fully open.
Your pipes may be clogged
A build up of minerals and other sediments in your plumbing system can cause a reduction of water flow. It doesn’t necessarily have to be a huge clog, even a small one can bring about this issue. If this is the case, your pipes need to be cleaned out or replaced by a professional plumber. Doing it yourself may lead to other problems as you may start pulling pipes and have a problem putting them back together. Corroded pipes may also slow down your water pressure as most metallic materials do have an “expiration date”. For example, galvanized steel pipes can last up to 20 years while copper pipes can last up to 50 years or more. The possibility of corrosion increases if your home is older and especially if it hasn’t been modernized. Lastly, corrosion can also take place if you have added additional plumbing fixtures such as a bathroom after the house has been built. Generally one is supposed to enlarge the branch lines of their plumbing.
Your pressure regulator may be faulty
Your pressure regulator could also be to blame. A pressure regulator is a control valve that reduces the input pressure in your plumbing system to a safe level that will not damage your pipes. A defective regulator will most definitely affect the water pressure throughout your home. It is possible to replace your regulator on your own though it’s not a bad idea as well to call a licensed plumber in Toowoomba so that they can determine whether the pressure regulator is the main issue or if there is another issue instead.
There is too much demand for water in your home
Some homes have many or multiple plumbing fixtures which can place a high demand on your water supply deeming it hard for proper water pressure to be maintained in every fixture. Luckily, this issue can be avoided with a little coordination. Also if you have one or a few fixtures with low flow, it could also mean that it has an issue. This could be because of a clogged aerator. An aerator is the little screen at the end of a faucet that can get rusted or clogged by debris. You could opt to remove the aerators and clean them up to remove any debris. After that, put it back and see whether there will be any difference. It would be best to get in touch with your local professional plumber to identify which of the two could be an issue.
Cracked pipe or leakage
When we think of a leaking pipe, there are so many ways that issue to be specific can cause so much damage and one of them is low pressure to your faucets. The leakage is misdirecting your water supply hence you are not getting the full flow. Be on the lookout for any wet spots or pools of water and identify which pipe is leaking. Make sure to turn off your water supply and wipe any areas with water as you wait for your local plumber to arrive and sort the situation.